There are plenty of ways to modify traditional steel club movements, and this week's video demonstrates one we've been using more frequently lately.
We're calling it a two handed mill with a front swing reverse.
It's a combination of a traditional mill, a front swing (or sweep), and a reversal that incorporates some leg drive.
How to Perform the Movement
Start with a two handed mill, casting the club behind your head and bringing it around into the front swing.
As the club travels across your body, bend your knees slightly. As you reverse the direction of the club, extend your legs to help drive the club back across your body and into the next mill.
You don't need to squat to a specific depth. A small knee bend works, but you can experiment with a deeper bend if you prefer.
The added leg drive helps power the reversal and brings more lower body involvement into what is typically an upper body dominant movement.
With enough repetitions and a challenging load, this variation can also become a pretty solid conditioning exercise.
Maintaining Tension Through the Swing
In the video, Nate uses our Cadi Club equipped with the Cadi Canteen, which has a fillable globe.
The shifting material inside the Canteen provides some audible feedback about how the club is moving.
As the club travels upward and reverses direction, you'll notice the load stays relatively quiet. That's a useful indication that the material is remaining loaded against the globe rather than abruptly shifting as tension changes.
The goal is to maintain a smooth, controlled swing rather than letting the club fall freely between movements.
Variations to Try
You can change the movement in several ways depending on your experience and training goals.
Try performing multiple mills before reversing direction, such as three or five mills followed by a front swing reverse.
You can also experiment with the amount of knee bend and leg drive used during the reversal.
For a more challenging variation, try performing the movement with one hand. Nate demonstrates a single arm version that incorporates hand switches behind the head during the pullover portion of the movement.
Start with a manageable load before attempting the single arm variation or adding significant weight.
A Note About Movement Names
One thing worth mentioning is that there isn't a universally accepted naming system for every mace and club movement.
Different people and training communities use different terminology, and that's fine.
We try to keep our descriptions as straightforward as possible. Rather than getting caught up in finding the perfect name for every variation, we'd rather explain what the movement actually involves.
In this case, two handed mill with a front swing reverse describes exactly what you're doing.
There's plenty of room to experiment with these movements and make them your own.
Watch the full video below for demonstrations of both the two handed and single arm variations.
Equipment used: CK Maceworks Cadi Club with Cadi Canteen.
Shop our adjustable steel clubs and maces at CK Maceworks.